Bakers Pride FC-816 Manual - Manual (Page 22)

22
SINGLE OVENS WITH FRONT MOUNTED CONTROLS
WHEN BUILDING YOUR FACADE, PROVISIONS MUST BE MADE FOR ACCESSING THE FOLLOWING:
(SEE SKETCH 14, PAGE 21)
FRONT:
LEFT SIDE:
REAR:
VENTILATION, AIR SUPPLY AND FIRE PROTECTION:
1. Hinged control access panel
2. Push-pull rods (2)
3. Arched opening and lintel plate
4. Combustion chamber door
1. Side service access panel (optional & recommended). Access to this panel eases potential service
access to the valve, booster burner control, booster burner ignition module and thermostat. However
all components may be accessed though front hinged controls access panel (difficult).
1. Rear booster burner, flame sensor and igniter - Provision should be considered for potential service
of these components. Following are 3 options:
A. Rear access panel (recommended).
B. Hinged or removable panel on the front of the facade to allow the removal of flue cover and
inserts. This provides greater access for a technician to service these components through
the front of the oven (see drawing below).
C. Through the arched bake chamber entrance (difficult).
2. Electrical connection
3. Gas connection
4. Minimum clearance for Service Technician and/or for safe operation
SEE INSTRUCTIONS ON PAGES 14-19.
BAKERS PRID
E
OPTION “B” ACCESS TO BOOSTER BURNER
Flue Cover
Insert
Insert
Lintel Plate