Autoquip FREIGHTLIFT FLT - Manual (Page 9)

9
SAFETY PRACTICES
WARNING !
Secure unit before making static inspections! Make sure the platform is
fully lowered and the power is turned off (disconnected at the safety
disconnect switch) before performing static inspections. Place signs at all
gates, doors, controls, etc. indicating the system is temporarily out of
service for routine maintenance per OSHA requirements for Lock-Out, Tag-
Out.
WARNING !
Never operate unit when parts are defective! Do not operate this
equipment when substandard or defective parts are in use! Contact an
Autoquip Service Representative to rectify all such situations.
WARNING !
Never go under platform carriage! Use a long-handled broom or similar
implement to remove debris that may accumulate.
WARNING !
Use properly rated hoses only! Never use fittings or hoses that are not
properly rated for the intended use.
WARNING!
Attach velocity fuse with solid fitting! Do not use a swivel fitting
between the velocity fuse and cylinder. If accidentally broken at the swivel,
the velocity fuse will not prevent the carriage from falling to the floor.