beautypg.com

The tools required for installation, Cutting torch with full tanks portable band saw, Installation – Autoquip FREIGHTLIFT FLT User Manual

Page 29: Instructions

background image

29


INSTALLATION

INSTRUCTIONS

THE TOOLS REQUIRED FOR INSTALLATION


Listed below are some of the tools needed to install the FREIGHTLIFT in a professional
and prompt manner. Individual site situations and a basic variation in the types of units
may dictate the need for additional items.

Welding Machine and Equipment

Hack Saw, Sawzall, or

Cutting Torch with Full Tanks

Portable Band Saw

Fire Extinguisher

Drill and Drill Bits

Forklift Extension

Cords

Chain Fall

Sledge Hammer

Come-A-Long

Open or box end wrench

Cables or Hook Chains with 1,000# Cap.

Drift Punch

Disk Grinder

Carpenter’s Square

“C” Clamps (12” opening)

Chalk Line

Socket Set (1/2” drive, sockets to 1 1/8”)

Plumb Bobs

Pinch Bar

4’ Level

Hammer Drill & Bits for 1/4”, 3/8” and

25’ Measuring Tape

1/2” anchors

Broom

The following supplies will also be needed:

*Concrete anchors (8 minimum) sized for the required minimum pullout of the base floor
channels and upper level bracing. Refer to the approval drawing since the size of the
anchors can vary for each installation.

*Concrete anchors for accessories, such as enclosures, approach ramps, etc. (Usually
1/4” diameter anchors and at least 12 anchors, minimum.)

*Shim stock for the floor channel, platform carriage corners, and/or approach ramp (if a
part of this installation)

*Hydraulic oil (see oil recommendations and tank capacity in “Specifications” section)

*Paint (Autoquip Blue: available in 1 and 5 gallons)

*3” x 3” steel angle iron or 4” channel for additional bracing

ALSO - BEFORE YOU BEGIN :
1. Beams are too heavy to lift manually and require lifting equipment. Check for
availability of overhead attachment of chain fall or of fork truck before you start.

2. Before you will be able to complete the installation the unit must be operated. Power
to the motor (even if temporary) is required. Arrange for power before starting
installation.