Autoquip PLTC DOCK LIFT - Manual (Page 50)

50
HOSE ORIENTATION
To prevent damage to the cylinder hose and possible failure of lift, it is necessary to
establish a correct hose shape and pattern of movement as follows:
1.
Raise the lift to its full height and block securely. See “Lift Blocking Instructions”.
2.
Install one end of the new hose to the cylinder elbow fitting.
3.
Since the hose is fixed at both ends, it is possible to put a twist in the hose that
will allow it to describe the same pattern each time the lift is operated. This twist
will allow the hose to travel about half way between the cylinder on the right side
and the inner leg on the right side.
4.
Lower the lift carefully and check to see that the hose is free and clear of the
cylinder and the inner leg assembly. If not, twist the hose in the direction
necessary to clear it of any obstruction and then lock the swivel fitting securely.
THROW-OVER BRIDGE
WARNING !
Any lift which has a hinged throw-over bridge damaged to the point of
hanging more than 30 degrees below horizontal is in violation of the
safety standards set forth in ANSI MH29.1 and MUST be taken out of
service until the bridge is repaired or replaced. Failure to do so could
result in severe personal injury or permanent damage to the lift.
ROCK SALT
It has been discovered that rock salt is being used to melt the ice and snow off of the
platforms in the northern region during the winter months. Rock salt will accelerate the
deterioration of any paint. Therefore, Autoquip recommends the use of a synthetic “Ice
Melt” product in lieu of rock salt.
Warranty on the paint finish will be denied when it is suspected that rock salt has been
used. Please contact the Product Support Team at Autoquip at 1-888-811-9876 or
405-282-5200.
GENERAL MAINTENANCE