Autoquip PLTC DOCK LIFT - Manual (Page 3)

3
IDENTIFICATION
When ordering parts or requesting information or service on this lift, PLEASE REFER
TO THE MODEL AND SERIAL NUMBER. This information is on a nameplate attached
to the leg assembly. Replacement parts are available from a local Autoquip distributor.
LIFT DOCUMENTATION
LIFT MODEL No: PLTC-_ _ _ _ _ LIFT SERIAL No: _ _ _ _ _ _ _ _
Date Purchased: ___ /___ /___
INSPECTION
Immediately upon receipt of the lift, a visual inspection should be made to determine
that the lift has not been damaged in transit. Any damage found must be noted on the
delivery receipt. In addition to this preliminary inspection, the lift should be carefully
inspected for concealed damage. Any concealed damage found that was not noted on
the delivery receipt should be reported in writing to the delivering carrier within 48 hours.
The following is a checklist that will aid in the inspection of the lift.
1. Examine entire unit for any signs of mishandling. Pay special attention to the
power unit and controls.
2.
Thoroughly examine all connections, making sure they have not vibrated loose
during transit.
3. After installation, raise the lift and inspect the base frame, platform, scissors
assembly, and cylinder plumbing connections.
PLANNED MAINTENANCE PROGRAM
A local Autoquip representative provides a Planned Maintenance Program (PMP) for
this equipment using factory-trained personnel. Call a local representative or Autoquip
Corporation at 1-888-811-9876 or 405-282-5200 for more information.
IDENTIFICATION & INSPECTION