Autoquip SERIES 35 SCISSORS LIFT - Manual (Page 25)

25
6. MAINTENANCE
6.1 Maintenance Device
NEVER go under a raised lift platform until load is removed and
lift is securely blocked in raised position with maintenance
device.
Lock-out/tag-out power source.
This procedure describes the only factory-approved method of working under a lift. Follow these
instructions EVERY
1. All loads must be removed from the lift prior to engaging the maintenance devices. These devices
are designed to support an unloaded lift only. Failure to remove the load from the lift prior to blocking
could cause the failure of the maintenance devices and allow the lift to fall unexpectedly. This can
result in personal injury or death.
time you plan to reach or crawl beneath the lift to perform service or maintenance –
no matter how momentary that might be.
If the factory-provided maintenance device is damaged or missing, stop immediately and consult the
factory for assistance. The manufacturer is not liable for your failure to use the approved maintenance
leg and procedures that have been provided.
2. Raise the lift to its fully raised position. If you do not, the maintenance devices may not be able to be
placed properly in their designed blocking position.
3. The lift will be provided with two (2) maintenance devices stored on the outside of the base frame.
The devices must be securely placed inside the base frame (B) and thus in the roller path of the lift
(See Figure 6.1 or 6.2).
A - Maintenance Devices Disengaged
B - Maintenance Devices Engaged
4. Lower the lift platform until the leg rollers or platform make contact with both maintenance device(s).
Re-check to ensure that both device(s) are fully and properly engaged. If the maintenance device(s)
is/are not fully engaged the lift could fall unexpectedly.
^ WARNING