Autoquip SERIES 35 SCISSORS LIFT - Manual (Page 22)

22
4.6 Toe Indicator Skirt
1. Position the platform in the raised position. Install the maintenance locks (see “Lift Blocking
Instructions”). Position the Toe Indicator skirt with the weight rod pocket at the bottom and the Internal
Horizontal Velcro strip at the top. See Toe Indicator Drawing.
2. The skirt should be mounted to the platform sides to allow the skirt to extend approximately 8” below
the bottom of the platform, see Toe Indicator Drawing. At the Skirt starting point, the skirt should have
a Vertical Exterior Velcro strip and an Internal Horizontal Velcro strip. Use the Horizontal Velcro strip
with adhesive back to attach the skirt to the platform sides, typical for all (4) platform sides. Start the
skirt 1/2” from Corner #1 and wrap the Toe Indicator Skirt ‘Clockwise‘ around the side of the platform.
Keep the skirt smooth and tight during the clockwise installation.
3. Before overlapping the skirt at Corner #1, insert the Weight Rods into the weight rod pockets. (1)
Weight Rod into Side ‘A’ pocket and (1) Weight Rod into Side ‘B’ pocket. Check the opposite ends of
each weight rod to insure the weight rod is fully inserted into each weight rod pocket. Wrap the skirt
around Corner #1 and attach the Vertical Interior Velcro strip on Side ‘A’ to the Vertical Exterior strip
on Side ‘B’.
4. After installing the Weight Rods in Side A & Side B, we need to install Weight Rods into Side ‘C’ and
‘D’. At Corner #3, on the OUTSIDE surface cut a 1” (max.) Vertical slot in the TOP of the weight rod
pocket. Insert weight rods in this slot, (1) for Side ‘C’ and (1) for Side ‘D’. The un-cut portion of the
weight rod pocket will retain the weight rods.