Atop Technology SE5416A Quick Start - Manual (Page 2)

Serial and Male DB9 Connectors
RS-232 RS-485 RS-422
Pin 1 - - -
Pin 2 RXD Data+ RX+
Pin 3 TXD - TX+
Pin 4 DTR - TX-
Pin 5 SG SG SG
Pin 6 DSR Data- RX-
Pin 7 RTS - -
Pin 8 CTS - -
Pin 9 - - -
*This cable (RJ-45 to Male DB9) is included in the package.
LED Indicators
Name Color Status Message
Power Green
On System is powered on
Off System is not powered on
Ready Green
Off
System is not ready or
halt
Blinking
AP firmware is running
normally
COM Green
Blinking
Data is transmitting on
COM port
Off No data is transmitting
LAN
Orang
e
On
Ethernet is connected at
100Mbps
Off
Ethernet is connected at
10Mbps or Disconnected
Green
Blinking
Data is transmitting on
this port
Off Ethernet is Disconnected
Field Maintenance and Service
 If the device requires servicing of any kind, you may need
to disconnect and remove it from its mounting. The initial
installation should be done in a way that makes this as
convenient as possible.
 Voltage/Power lines should be properly insulated as well
as other cables. Be careful when handling them so as to
not trip over.

Do not under any circumstance insert foreign objects of
any kind into the heat dissipation holes located in the
different faces of the device. This may not only harm the
internal layout, but might cause harm to you as well.
 Do not under any circumstance open the device for any
reason. Please contact your dealer for any repair needed
or follow the instructions on section of your manual.
Warranty Policy
Warranty Conditions
Products supplied by Atop Technologies are covered in this
warranty for sub-standard performance or defective
workmanship. The warranty is not, however, extended to
goods damaged in the
following circumstances:
(a) Excessive forces or impacts
(b) War or an Act of God: wind storm, fire, flood, electric
shock, earthquake
(c) Use of unqualified power supply, connectors, or
unauthorized parts/kits
(d) Replacement with unauthorized parts
RMA and Shipping Costs Reimbursement
Customers shall always obtain an authorized "RMA" number
from Atop before shipping the goods to be repaired to Atop.
When in normal use, a sold product shall be replaced with a
new one within 3 months after purchase. The shipping cost
from the customer to Atop will be reimbursed by Atop.
After 3 months and still within the warranty period, it is up to
Atop whether to replace the unit with a new one; normally, as
long as a product is under warranty, all parts and labor are free
of charge to the customers.
After the warranty period, the customer shall cover the cost for
parts and labor. Three months after purchase, the shipping
cost from the customer to Atop will not be reimbursed, but the
shipping cost from Atop to the customer will be paid by Atop.
Limited Liability
Atop shall not be held responsible for any consequential losses
from using Atop’s product.
Warranty Period
The Warranty Certification will not be effective until an
authorized stamp issued by Atop’s overseas agents.
Purchase Date: / / (yyyy/mm/dd)
Serial Number:
ATOP Customer Services and Supports
1. Please contact your local dealers or Atop Technical Support
Center at the following numbers.
+886-3-550-8137 (Atop Taiwan)
+86-21-6495-6232 (Atop China)
2. Please report the defected problems via Atop’s Web site or
E-mail account
Web Site: www.atop.com.tw e-mail: [email protected]
Web Site: www.atop.com.cn e-mail: [email protected]
-Any changes to this material will be announced on Atop website.-
Product Categories Warranty
Ethernet Switches
5 Years
Wireless
Serial Device Servers 
Modbus Gateways
Embedded Device Servers
DIN-Rail Power Supplies 3 Years
Power Adaptors
1 Year Antennas
Other Accessories