Warranty policy, Led indicators, Signal leds – Atop Technology SW550X Installation Guide User Manual
Page 2: Unit dimensions and layout (unit=mm)

Warranty Policy
Warranty Conditions
Products supplied by Atop Technologies are covered in this warranty for
sub-standard performance or defective workmanship. The warranty is
not, however, extended to goods damaged in the following
circumstances:
(a) Excessive forces or impacts
(b) War or an Act of God: wind storm, fire, flood, electric shock,
earthquake
(c) Use of unqualified power supply, connectors, or maintenance
procedure
(d) Replacement with unauthorized parts
RMA and Shipping Costs Reimbursement
Customers shall always obtain an authorized "RMA" number from Atop
before shipping the goods to be repaired to Atop. When in normal use,
a sold product shall be replaced with a new one within 3 months after
purchase. The shipping cost from the customer to Atop will be
reimbursed by Atop.
After 3 months and still within the warranty period, it is up to Atop
whether to replace the unit with a new one; normally, as long as a
product is under warranty, all parts and labor are free of charge to the
customers.
After the warranty period, the customer shall cover the cost for parts
and labor.Three months after purchase, the shipping cost from the
customer to Atop will not be reimbursed, but the shipping cost from
Atop to the customer will be paid by Atop.
Limited Liability
Atop shall not be held responsible for any consequential losses from
using Atop’s product.
Warranty
5 Years
3 Years
Product Categories
Ethernet Switches
Wireless
Serial Device Servers
Modbus Gateways
Embedded Device Servers
DIN-Rail Power Supplies
Power Adaptors
Antennas
Other Accessories
1 Year
Warranty Period
─ Any change by website in material announcement primarily. ─
The warranty certification will not be effective until an authorized stamp
issued by Atop’s overseas agents.
Purchase Date: / / (yyyy/mm/dd)
Serial Number:
ATOP Customer Services and Supports
1. Please contact your local dealers or Atop Technical Support Center at
the following numbers.
+ 886-3-550-8137 (Atop Taiwan)
+ 86-21-6495-6232 (Atop China)
2. Please report the defected problems via Atop’s Web site or E-mail
account
Web Site:www.atop.com.tw, e-mail:[email protected]
Web Site:www.atop.com.cn, e-mail:[email protected]
■
Unit Dimensions and Layout (unit=mm)
Device Dimensions,
Physical Appearance and Mounting
Proceed to mount the SW550X in a dry location free from dirt and
corrosive vapors, for more questions on environmental limitations
please refer to the User’s manual.
The Industrial Wireless Serial Device Server and dimensions are
shown below.
Left Side View
Right Side View
Rear View
Top and Bottom View
Front View
SW5501
LED Indicators
Color
Status
Name
Data transmitting on the serial port
Data is not transmitting on the serial port
Ethernet is connected on 10Mbps
Ethernet is connected on 100/1000Mbps
Ethernet is disconnected
Data is transmitting on Ethernet
Wireless Radio is enabled
Wireless Radio is enabled and data is
transmitting
Wireless Radio is disabled
System is not powered on
AP firmware is running normally
AP firmware is not running
Description
Blinking
Off
Blinking
On
Off
Blinking
On
Blinking
Off
Off
Blinking
Steadily
Blinking
Rapidly
Green
Orange
Green
Green
Green
COM
LAN
WLAN
RUN
Signal LEDs
Status LED1 LED2 LED3 LED4 LED5
Operations
Connecting
Connected
Searching for an AP
Cannot connected to the AP
No IP provided by the DHCP
Server
Signal Strength is less 20%
Bad Signal Strength (20%-40%)
Poor Signal Strength
(40%-60%)
Fair Signal Strength (60%-80%)
Good Signal Strength
(80%-94%)
Excellent Signal Strength
(95%-100%)
○
off
●
on
☼
blinking
☼
☼
☼
●
●
●
●
●
●
☼
☼
●
●
●
●
●
☼
●
●
●
●
☼
●
●
●
☼
●
●
☼
●
SW5501-TB/Sis
SW5502
SW5502-TB/Sis
F.G.
V-
V+