On the right side by pushing the pin of the, Inside the face seal, Pivot stop on the left side – ArcOne Clean Air Flow User Manual

Page 27

4.7 Airduct Headgear Assembly Replacement

Welding

Helmet Shell

Airduct Headgear Assembly
(CA-HGA-01)

Face Seal

(CA-COL-XX)

Knob

Pivot Stop

Bolt

Step 1-3 refer to Figure 9 insets
1. Place the Pivot Stop inside the Face Seal

on the right side by pushing the pin of the

Pivot Stop into one of the holes on the

helmet.
2. Place the Airduct Headgear Assembly

inside the Face Seal

and over the Pivot

Stop boss.
3. Insert the Airduct Headgear Assembly
Bolt through the Airduct Headgear

Assembly lining up all three rectangles

(Bolt, Face Seal, and Welding Helmet
Shell).
4. Screw the Knob onto the Bolt.
5. Repeat on the left side.

NOTE: there is

Pivot Stop on the left side.

Figure 30