ArcOne Clean Air Flow - Manual (Page 11)

Filter Installation:
1. Remove any Filter packaging from the Filter.
2. Remove the Filter Cap from the Blower (fi g. 3).
3. Remove the old fi lter (if installed).
4. Install the Filter onto the Blower (fi g. 4).
5. Install the Filter Cap onto the
Blower, making sure the left and
right tabs snap onto the Blower.
6. Check the Filter Cap is secured
(fi g. 5).
7. Repeat step 5 and 6 if Filter
Cap detaches from the Blower.
Pull tab away
(left & right)
#1
#2
Pull
#3
Figure 3
Figure 4
Figure 5