Anchor CLASSIC SOLID SAFETY POOL COVER - Manual (Page 6)

6
DECK
UNFOLD
LEFT
UNROLL TO
RIGHT DECK
COVER
BUCKET
(TYP.)
UNFOLD
TOWARD THIS
END OF POOL
SPA
STEP 2
:
PREPARE POOL FOR INSTALLATION
1) It is best to have water level so that there is approximately 15” from pool’s edge to where cover
rests on water.
2) Remove all handrails, ladders, etc.
3) Unfold cover onto deck. DO NOT DRAG THE COVER.
4) Position buckets (filled with water) around pool.
STEP 3
:
PLACING COVER OVER POOL
1) Place bundled cover as shown.
2) Unroll pool cover at end of pool as illustrated below. (Black web/hem side down.)
3) Install a rubber tie (see Step 5). Position a water bucket on rubber tie at center location.
4) Once cover is unrolled, start unfolding cover towards opposite end and place water buckets on
rubber ties across from each other. Continue doing this until pool cover has completely
covered pool.
NOTE: Do not place water buckets on cover, damage may occur. Place water
buckets only on ties.
BUNDLE
PLACED AT
END OF POOL
BUCKET
(TYP.)
DECK
SPA
WATER
POOL
COVER
SPA
15” 15”