Anchor CLASSIC SOLID SAFETY POOL COVER - Manual (Page 11)

11
STEP 9: STEP WEDGES
INSTALLING STEP WEDGES
1. Before tightening the pool cover anchors near the steps, tuck step wedges under the overlap edge of the
cover, as needed.
2. Pull the outer edge of the cover to the outside flap of the wedges and clip the flap to edge of the cover us-
ing the clips for step wedges provided.
3. Install the rubber ties and anchors to tighten the cover.
4. Be sure that the last rubber ties near the top and bottom steps are snugged up close to the wedge to se-
cure it firmly in place.
5. Step Wedges come in standard sizes of 14” and 28” (measured on the horizontal dimension along the
step). Custom sized wedges can be made upon request.
POOL COVER
w/ OVERLAP
POOL COVER RUBBER
TIES SNUGGED CLOSE TO
BOTTOM STEP WEDGE. STEP WEDGES TUCKED UNDER EDGE
OF POOL COVER OVERLAP AND
CLIPPED AT OUTER FLAP.
RUBBER TIES
LOOSENED UNTIL
STEP WEDGES ARE IN
PLACE
WEDGES FOR
DESCENDING
SIDE.
CLIP FOR
STEP
WEDGES