Anchor CENTURY 40 WIDE - Manual (Page 2)

MANPOWER REQUIRED
Five experienced installers
should be able to assemble a
40’ x 60’ tent in approximately
four hours.
TOOLS REQUIRED
Sledge Hammers
Stake Driver
2 Measuring Tapes
INSPECT SITE
Caution:
Consult your local utility locator service or the
National Utility Locating Contractors Association
(NULCA) prior to installation. Prior to actual
tent assembly, be sure to look up, down, above
& below for obstacles, pipes, wires, trouble, etc.
LAYOUT & CHECK
Utilize parts list for a quick I.D. and a check list
to ensure that you have all the parts.
PARTS
QUANTITY PER SECTION
END (PAIR) 20’ MIDDLE
BAG WITH FABRIC SECTION 2 1
CENTER POLE 1 1
SIDE POLE 16 4
POLE CAP (OPTIONAL) 1 1
SEE WEB GUY LAYOUTS & STAKING TABLES FOR STAKING REQUIRE-
MENTS.
Pole Cap (optional)
Bag with Fabric
Section
Center Pole
Side Pole
Stake driven through
hole in bar and winch
plate
Stake line
Stake line
4’ STAKE BAR 2’ STAKE BAR
Stake driven through
hole in bar and
winch plate
Parts Illustrations
2
IMPORTANT:
The installation of this Century Tent should be performed/supervised by knowledgeable tent installers with a clear
understanding of safety issues as well as the methods of anchoring. The requirements as specified with blue print
(supplied by Anchor Industries Inc.) must be followed. The installer/owner must read the assembly instructions
completely prior to any installation. Particular attention must be given to anchoring! See Caution Statement on back
page of this manual.