Anchor CENTURY MATE 30 & 40" WIDE EXPANDABLE - Manual (Page 5)

Start at side opposite wind. Insert each side
pole pin into side pole hole and raise slightly
less than perpendicular. Bottom of each pole
should be pointed inward toward center of tent.
Tie jump rope around each side pole.
Continue around tent.
RAISE SIDE POLES
5
One installer to guide center pole pin through
hole to prevent snagging or tearing of fabric as
pole is being raised to position.
Raise to upright position and tie off jump rope to
pole.
At this point, properly stake all center poles to
prevent movement. Lash pole to two stakes
(not provided).
RAISE CENTER POLES
CAUTION:
6
1. Spread ground cover.
2. Slant side poles inward.
3. Remove center and side poles.
4. Reverse installation steps.
TAKE DOWN
8
GUY WEB
SIDE POLE PIN
WIND
JUMP
ROPE
JUMP
ROPE
Tighten guy webs and then set side poles to
upright position. Adjust pole positions and guy
line tension to
properly pull out tent.
Protective covers are recommended for all
stakes.
SIDE POLE ADJUSTMENT
7
JUMP
ROPE
CHECK WEB GUYS PERIODICALLY FOR
TIGHTNESS AND CONDITION.
IMPORTANT:
5