Anchor EVENT AND VENUE LINER - Manual (Page 5)

5
Venue Mid Eave Liner Cable
Step 5 - For Venue
Eave cables with turnbuckles (Figure 5f) are required for mid liner installation. Loosen nuts and bolts at location shown in
Figure 5e, slide L-bracket in place and tighten bolts. Adjust turnbuckle until cable is tight.
Cables for mid fastens into
L-Bracket
Gable end
Mid Eave Bar
Figure 5e
Figure 5f
L-Bracket
Step 6
Attach quick links and tie pull rope as shown in Figures 6a & 6b. Run rope thru ey-
enut as shown in Figure 2. Run rope back down and behind eave cable as shown
in Figure 6c. All ropes should run to the same side for an even fi t.
Figure 6b
Quick links
Figure 6a
Liner Ridge Tubes
Quick Link
Turnbuckle
L-Bracket
L-Bracket