Bosch B20CS5 - Manual (Page 20)

21
Installation instructions
Important information:
These installation instructions refer
to various models.
Not all steps are required for some
models.
The appliance may be connected
only by an authorized fitter
according to these installation
instructions.
Always connect the water before
the power.
In addition to the statutory
national regulations, observe the
connection conditions of the
electricity and water supply
companies.
Keep the installation instructions
in a safe place.
Installation location
Warning:
The appliance is very heavy, for
empty weight see the following
table.
Basic model 229 lbs
(104 kg)
Model with dispenser 248.5 lbs
(113 kg)
Install the appliance in a dry, well
ventilated room. The installation
location should neither be exposed
to direct sunlight nor near a heat
source, e.g. a cooker, radiator, etc.
If installation next to a heat source is
unavoidable, use a suitable
insulating plate or observe the
following minimum distances to a
heat source:
- 1
1 /
4
" (3 cm) to an electric
cooker.
- from an oil or solidĆfuel cooker
11 3 /16" (30 cm).
The floor on which the appliance is
to be installed must be rigid.
If required, reinforce the floor.
To ensure that the ice maker
functions correctly, the appliance
must be upright. To ensure that the
doors can open all the way, observe
lateral minimum distances when
installing the appliance in a corner or
recess (see section on Appliance
and installation dimensions").
Unpacking the
appliance
q Remove packaging material and
adhesive tape. (Adhesive
residue on the housing can be
removed with the adhesive side
of the removed tape. To do this,
repeatedly place the adhesive
tape on the adhesive residue
and remove).
q Do not remove the
transportation protection
devices from the shelves and
storage compartments until the
appliance has been installed.
q After installing the appliance,
remove the transportation
protection devices from the ice
maker. To do this, pull out the
ice maker.
Warning:
Before connecting the appliance to
the power supply, remove all the
inner and outer packaging material.