AMMCO AC2000M Motorcycle Lift - Manual (Page 10)

Model: AC2000M
Installation, Operation & Maintenance
10 Rev: 4/13/11
QML02E-IOM-E
 Warning Notice
WARNING
Use the lift after carefully reading the instruction manual and
understand the contents of them for safe and proper use of the
motorcycle lift.
< During preparation>
1. This Lift is for motorcycle use only. Do not use for any other
purpose.
2. Do not use the lift whenever any of the safety devices are not
operating properly.
3. Be cautious and smooth when loading or removing motorcycles
from lift.
4. Be careful of footing when the tire, floor, or lift is wet.
< During lifting and lowering the lift >
5. Always watch the motorcycle while operating the lift to ensure
that there are no problems taking place while raising or lowering.
6. If several lifts are installed, observe the location of the switch to
be clear of any obstacles.
7. Do not lift a motorcycle exceeding the rated capacity of the lift.
8. Do not lift a motorcycle with people or any other load.
9. Check for oil or foreign material on the lift.
10. Only raise the lift after verifying that the motorcycle is properly
positioned.
11. Stop raising the lift after it has reached its maximum height.
12. When raising or lowering the lift, wait 1 or 2 seconds before the
next operation is carried out.
13. Do not shake the motorcycle during lifting and lowering of the
lift. If the motorcycle is settling to one side, stop the operation of
the lift immediately.
14. If the lift is not lowering in spite of pressing the down pedal, raise
the lift and then press the down pedal again.
15. After the lift is completely lowered, the motorcycle can be loaded
or removed from the lift.
16. Prohibit unauthorized persons from standing near the lift while it
is being raised or lowered.