Replacing the crossfader / face plate – Allen&Heath XONE 42 User Manual
Page 26
Allen & Heath 26 XONE:42 User Guide
REPLACING THE CROSSFADER / FACE PLATE
Replacing the Crossfader
−
Firstly, pull the crossfader cap vertically off the fader shaft and put it somewhere sensible.
−
Use a medium size cross-point screwdriver to undo and remove the two outer screws on the
crossfader plate.
−
Carefully pull the crossfader assembly away from the front panel.
−
Unplug the cable from the old crossfader, and once the crossfader assembly is detached, un-
screw the two inner screws to separate the fader from the plate.
−
Fit the new crossfader, put the inner screws back in, and re-connect the cable.
−
Check that the connector is correctly aligned and pushed on.
−
Replace the assembly making sure the cable faces the right-hand side of the console.
−
Refit the outer screws and test operation.
Standard Alpha Crossfader Part Number— 003-829 JIT
Penny & Giles Crossfader Option Part Number— 002-719 JIT