Allen&Heath XONE 4D User Manual
Page 26
Allen & Heath
26
XONE:4D User Guide
MIXER SECTION — MIX AND MONITOR
1
3
4
5
6
7
8
Mix / Monitor Meters
The main meters follow the selected
monitor source. The meter reads ‘0’ for
an XLR output of +4dBu. The mixer
should be operated with these meters
averaging around ‘0’ with loudest peaks no
higher than ‘+6’.
1
Mix Master Level Control
A rotary master control adjusts the level of
the main mix XLR outputs feeding the house
sound system. This does not affect the mon-
itor output or the meter reading.
3
Monitor Master Level Control
Adjusts the level of the signal to the stereo
monitor RCA output. This does not affect
the headphones. The monitor output could
be used for a booth monitor, recording or
an additional zone feed.
4
Cue Active LED
A large red LED indicator lights when a
channel CUE is active. This indicates that
the selected channel CUE signal is heard in
the headphones and displayed on the
monitor meters.
5
Monitor Select Switches
In the normal ‘up’ position the headphones
and meters monitor the pre-level main mix.
Press these switches to select either of the
stereo FX mixes as the headphones and
meter source. Note that this does not affect
the main mix or monitor outputs.
6
2
Record to FX2 Switch
Selecting this switch will send the pre-fade
mix output to the FX2 Send RCA sockets
on the rear of the mixer.
The mix signal is switched after the
internal FX2 buss, allowing the FX2 Send
controls to still be used for software effect
loops and a source for the BPM counter.
2