Allen&Heath GL4000 SERVICE MANUAL - Manual (Page 107)

RPSD2 & RPSD
SPECIFICATION :
Bridge diode power steering / combining. Window comparator voltage detectors, AC ripple detection.
DC IN CONNECTIONS
RPSD RPSD2
Two 5 pin XLR male connectors Two 5 pin XLR male connectors
Two 10 pin round male connectors
5-pin XLR male +16V 4A max 10-pin male +16V 5A max
-16V 4A max -16V 5A max
+48V 200mA max +48V 200mA max
DC OUT CONNECTIONS
RPSD RPSD2
8-pin locking Cinch socket 10-pin screw locking round socket
MAINS IN ........................................... 100-240V AC @ 8A max. with RFI filtered input.
MAINS FUSE ..................................... T 8A 250V 20mm.
MAINS OUT ....................................... 100-240V AC @ 5A max on two IEC 3pin sockets.
MONITOR CIRCUITS ........................ 2 independent self powered power supply monitor circuits.
........................................................... 4 tricolour flashing LED indicator display per monitor circuit.
Voltage range limits .......... ±16V ....... 13-18V
.......................................... +48V ....... 35-56V
Ripple/noise limits .............................. >500mA
POWER REQUIREMENT (power consumption from each supply)
+16V ................................................... 25mA
-16V .................................................... 5mA
+48V ................................................... 12mA
REMOTE ............................................ +/-16V @ 100mA max. from each rail.
........................................................... 'good' status NPN open collector 100mA max.
DIMENSIONS (unpacked) ................. 482 x 45 x 145mm 19" x 1.75" x 5.7" width x height x depth
.................. ....(packed) ..................... 570 x 75 x 340mm 22.5" x 3" x 13.5"
WEIGHT ... (unpacked) ..................... 2.5 kg 5lb
.................. (packed) ......................... 2.6 Kg 5.5lb
ACCESSORIES ................................. RPSD - GL4 console 3m DC cable (A&H Part no: 002-060)
........................................................... RPSD - GL4000 console 3m DC cable (A&H Part no: 002-227)
........................................................... RPSD2 - GL4000 console 3m DC cable (A&H Part no: 002-223)
........................................................... DC cable 3m 5-pin fem XLR to 10-pin male (A&H Part no: 002-225)
........................................................... IEC 3-pin male to female mains cables (A&H Part no: AH2262)
........................................................... User Manual (A&H Part no: AP2263)
For those who spend much of their lives behind the equipment rack the RPSD2 & RPSD units also have main
status indicator LEDs (OK) for each supply located on the rear panel. This should prove useful if you need
to unplug a faulty unit mid session. A stable green LED will show which supply is still good.
If the RPSD2 or RPSD is to be used in an isolated position that obscures direct vision then remote indicators
can be connected using the 9 pin D connector on the rear. This includes a feed from each DC rail through a
10 Ohm protection resistor. These may be used to drive remote LED or lamp indicators through suitable current
limiting resistors, or alternatively to power low current ancillary circuits up to 100mA. Also included is an
open-collector transistor output for each supply status. Logic 0V = 'good'. This can be connected to an
indicator powered from one of the positive rails, or drive a suitable relay or other switching circuit.
SPECIFICATION