Allen&Heath GS1 SERVICE MANUAL - Manual (Page 13)

ALLEN & HEATH 1 3 S1SM1
ASSEMBLY (REAR POSITION)
As supplied the front panel and PCB are assembled in the extrusion the correct way round for mounting at the rear of
the console.
Attach Meterbridge to sides of front panel as shown in using M3
screws supplied ITEM 1
Connect IDC cable as shown ensuring correct orientation.
5
1 3
Apply self adhesive facia ITEM 4 to the front panel ITEM 5 ensuring correct alignment with the meter
slots.
2 Attach side trims ITEM 6 to the extrusion ITEM 7 using the self tapping screw supplied ITEM 2 The
Left hand side trim has a rebate for the IDC cable. Care should be taken not to trap the cable when attaching
the side trim.
Remove screws from left hand extrusion and plastic end cap and slide out extrusion as shown.
It may be necessary to loosen screws "A" to enable side extrusion to slide.
4