AirLive WHA-5500CPE-PCBA - Manual (Page 44)

3. Basic Configuration
3.4.3 Repeater Node Local service Settings
Setup Wizard>>Wireless Settings
In the Setup Wizard, select the WLAN mode, in this case, only the WLAN mode and SSID
can be modified, the channel will automatically readjusted as the upper node.
Set the SSID for the Hotspot service. This SSID can be different from upper node’s SSID.
Its Channel will be display as “Auto” it will be same as the AP node’s channel. It’s
necessary to set the Wireless mode as the same spectrum as AP’s node.
You can set encryption for the security between hotspot services with client device.
3.4.4 Repeater Advance Wireless Setting
Advanced Settings>>Wireless setting
Beacon Interval: The WHA-5500CPE broadcasts beacon frames regularly to announce
its existence. The beacon Interval specifies how often beacon frames are transmitted in
time unit of milliseconds. The default value is 100, and a valid value should be between 1
and 65,535.
RTS Threshold: RTS/CTS frames are used to gain control of the medium for transmission.
Any unicast (data or control) frames larger than specified RTS threshold must be
transmitted following the RTS/CTS handshake exchange mechanism. The RTS threshold
should have a value between 256-2347 bytes, with a default of 2347. It is recommended
that this value does not deviate from the default too much.
Fragmentation: When the size of a unicast frame exceeds the fragmentation threshold, it
AirLive WHA-5500CPE User’s Manual 38