2 – setting gps laptimer – AiM GPS05 Module User Manual

Page 17

GPS05 Module

User manual
Release 1.01

4 0

4.4.2 – Setting GPS Laptimer

Once MyChron4 is correctly configured it is necessary to go on the track to set lap
and split positions giving correct instructions to the GPS05 Module.
This allows it to get beacons.

Warning: this operation is required the first time entering the track and only

once for each track.

To set lap/splits position switch MyChron4 on and press ON/View button until “G.P.S.
Data” page - shown below - appears:

Note

: it may occur that at first the page shows “Initializing” in spite of “OK to begin

settings”; just wait a few moments and the correct message appears.
To correctly set lap and split positions it is suggested to run the first track lap more
slowly so to have enough time to enter the desired points of the track.
Press OK button to begin settings (or VIEW button to exit).
If the logger is configured not to sample split times this window appears:

To set Start/Finish line

press OK button once reached the desired position on the

track and Start/finish line position is saved (press VIEW button to exit).