Connection to lan – 2N Helios IP Video Kit User Manual
Page 13
13
Legend
Group
Terminals
Function
DC in
9-36V/1.5A power input
LAN1
LAN connection with PoE function
LAN2
LAN connection
D1
Integrated red and green LED indicators
VIDEO
+12V, VGND,
IN1, IN2
Connection of up to two analog cameras connected via
composite PAL or NTSC signal
RESET
RESET multifunction button
AUDIO
MODULE
Connection of an audio module with microphone,
loudspeaker, buttons and LEDs
RELAY
NO, COM, NC
Programmable relay switch with an accessible N/O and
N/C contact
LEDs
LED1+, LED1-
LED2+, LED2-
3 current outputs for connection of programmable LED
indicators; two terminals per LED
KEYBOARD
COL1-4
ROW1-4
Connection of matrix keypad (4x4) or 16 separate
buttons
OUTPUTS
OUT1+,
OUT1-
OUT2+,
OUT2-
2 programmable active 12V DC/650mA outputs
INPUTs
IN1+, IN1-
IN2+, IN2-
2 programmable galvanically isolated inputs
AUDIO
MIC+, MIC-
IN+, IN-
OUT+, OUT-
Microphone input, line input, line output
SPEAKER
SPK+
SPK-
Power amplifier output for loudspeaker
Connection to LAN
Connect
to the LAN using an RJ-45 terminated UTP/STP
2N
®
Helios IP Video Kit
cable (of category Cat 5e or higher). As the device is equipped with the Auto-MDIX
function, you can use either the straight or crossed cable version.
2N
®
Helios IP Video Kit is equipped with two LAN interfaces (LAN1 and LAN2) and
an integrated Ethernet switch. You can use only LAN1 interfaces for LAN connection.
LAN1 is the only interface provided with PoE. LAN2 helps connect another LAN device
on the installation site. This interface is not equipped with PoE.
Note
2N
®
Helios IP Video Kit does not allow you to feed another connected
device via PoE. The integrated PoE function is intended for the 2N
®
supply only.
Helios IP Video Kit