1 configuration, Static/dynamic address setting mode switching – 2N Helios IP Uni User Manual
Page 19
19
3.1 Configuration
2N
®
Helios IP Uni Use a PC equipped with any web browser to configure:
Launch your web browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (
, e.g.).
Log in using the
user name and
password.
Admin
2n
You have to know the IP address of your device to log in to the integrated web server.
By default,
is switched into the dynamic IP address mode, i.e. it
2N
®
Helios IP Uni
obtains the IP address automatically if a properly set DHCP server is available in your
LAN. If no such DHCP server is available, you can operate
in the
2N
®
Helios IP Uni
static IP address mode. Refer to the
for
IP
configuration details.
If your device remains inaccessible (you have forgotten the IP address, or the LAN
configuration has changed, for example), change the LAN settings using the buttons on
the device.
Static/Dynamic Address Setting Mode Switching
In case your
device is equipped with 1 or 2 buttons, you can
2N
®
Helios IP Uni
switch the modes using one button only.
Connect
to the power supply (or, disconnect and reconnect it
2N
®
Helios IP Uni
if already connected).
Wait for the first acoustic signal
.
Press button 1 fifteen times.
The acoustic signal
indicates mode switching.
Wait until the device is restarted automatically.
Note: The 15-times-1 sequence must be entered within 30 seconds after the first
sound signal for security reasons. The inter-digit delay may be 2s at most
The static IP address mode will be switched into the dynamic IP address mode and vice
versa upon restart.