2N Helios IP Uni - Manual (Page 17)

17
2N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
1.
2.
3.
4.
2.3 Button Tags
This subsection describes work with Button Tags in . 2N
®
Helios IP Uni
Tag Printing
Every delivery includes a sheet of translucent foil, which can 2N
®
Helios IP Uni
be laser-printed. Cut the printed foil and insert the tags in the name plates.
Every name plate includes a piece of foil, which can be written over manually,
using a waterproof permanent marker, if necessary.
Tag Inserting / Replacing Instructions
2N
®
Helios IP Uni provides an intuitive, easy access to the name plates. The tags are
easy to insert and replace even without a manual. You need not remove the front panel
and thus are not exposed to the risk of loss of components while replacing the tags.
Loosen the name plate screw using the wrench enclosed,
for example. You can open the name plate window like a
door without losing the tightened screw.
Remove the used or blank name tag and insert a new
tag.
Close the name plate window and tighten the screw
appropriately.
Check the click effect of the buttons: if the button fails
to click properly when pressed (when moved by approx.
0.5 mm), the tag is too thick or thin. Make sure that the
button clicks when you press it on both ends.
Note
Always use waterproof foil (enclosed or other) for the tags. Never use
paper or ink jet printing to avoid damage due to water leakage!