beautypg.com

Omega lite installation manual – 2N Omega Lite - Installation Manual v1.5 User Manual

Page 42

background image

2N

®

- OMEGA Lite

Installation manual


Installation manual

42

www.2n.cz


Serves for network parameter setup (IP address/network mask,.).

After the network parameters have been set up you may disconnect.

Always RESET the module using the SW1 button after disconnecting the USB
cable.

Connect a standard direct Ethernet cable into the J1 connector.


This cable connects the VoIP module with your Ethernet network.

After turning the PBX power on you may start configuring the VoIP module.

!