2N Omega Lite - Installation Manual v1.5 - Manual (Page 29)

2N
®
- OMEGA Lite
Installation manual
Installation manual
29
www.2n.cz
Note: In places with a poor level of GSM signal it is possible to use an independent
(external) GSM gateway which can be installed at a distance of up to 500 m from the PBX (!)
in a place with a good GSM signal (on high building, hill etc.) and ensure both cheap access
to the GSM network and reliable function in places where there is very poor coverage
(borderline areas).
6.2. Unpacking and checking
If you haven’t yet done so, check that the delivery is complete. The packaging of
the basic module is usually used for the transport of other independently purchased
items of the PBX (modules etc.). You can usually check them using the delivery note
and order numbers which are on all parts. The remaining components in the upper
part of the box are the accessories of the basic module. Remove the separate basic
module from the upper part. Open it and check everything against the packing sheet,
which is a separate annex to the documentation. Check whether there was any
mechanical damage to the parts during shipping. On the top of the box there is a
printed reinforcing piece which serves as a drilling template for the mounting of the
PBX. Keep the packaging (especially from the extender modules).
6.3. Installation of extender module
First connect an extender module (extender) using connector J1 with the
motherboard (connector J1) and then affix it to the chassis of the basic module
using six screws.