2N Omega series - Configuration Tool manual v1.9 - Manual (Page 15)

15

FLASH length to CO. Enter the length of the FLASH signal generated by the
PBX to the external port.

Dial pulse to CO. Enter the length of the dial pulse‟s impulse to the external
port.

Dial gap to CO. Serves to set the gap length for pulse dialling to an external
port.

Gap between numbers PV. Serves to assign the gap length for pulse dialling
sent to an external pulse.

DTMF dial length. Serves to assign the length of broadcasting the dual tone
multi-frequency (DTMF) dialling to an external port. This value also determines
the DTMF dialling pause.

Waiting for a CPT CO. Determines the maximum period the PBX spends trying
to detect the external dialling tone used to determine the working of the external
port.

DTMF dial CO translation. The dialling gap for an internal tonal line to an
external tonal line after which the dialling to the external line is only heard.

Test Repetition CO. How much a faulty external line test is repeated.

CO OUT Relax. The minimum time for suspending an external line after an outgoing
call.

CO In Relax. The minimum time for suspending an external line after an incoming
call.
 
End of waiting on a DISA/FAX/modem. The time an incoming external call
waits after detection by the CNG (fax signal) or after direct inward calling on a
free or engaged subscriber before hanging up on the external line or carrying on
with another row in the call table.

1
st
dial to CO time. The maximum time for delay when dialling an external line.
If there is no dialling during this time the external number is hung up on.

Dial to CO time. The maximum time for delaying in dialling an external line. It is
renewed after every new number dialled by the internal user and, after it has
expired; the device switches from dialling to calling. It is permissible for the
expiration of this time to be marked by a short peep. Any other calling after this
time has elapsed is considered to be a call service.

Dial to GSM time. The maximum time for dialling another call to a GSM line. It
is renewed after every new number dialled by the internal user and, after it has
expired; the device switches from dialling to calling. It is permissible for the
expiration of this time to be marked by a short peep. Any other calling after this
time has elapsed is considered to be a call service

Max call time without break-up. The maximum time for a call of two external
lines that have connected break up signalling.

Max call time with break-up. The maximum time for a call of two external lines
that do not have connected break up signalling.

Trace ISDN. The selection allows the type of diagnostics for the ISDN modules
to be set after restarting the PBX.

ISDN blocking time after extern. busy. The time for which the ISDN line is not
accessible after a previous occupancy by external equipment (e.g. by an ISDN
modem).