Echo 72928 Owners Manual v.2 - Manual (Page 13)

10
S E C T I O N 2
2.3 Operation
2.3.1 Starting: 28 HP Kubota Model
CAUTION: Move machine to a clear, level area
outdoors before starting. Do not operate machine
on a paved, concrete, or gravel surface. Do not operate
in the vicinity of bystanders. Make sure cutting chamber
is empty before starting.
1. Before starting, fill engine with oil to the correct
level. See engine manual for additional starting,
operation, and maintenance instructions.
NOTE: Some oil usage is normal. Check level with
each use.
WARNING: Handle fuel with care. It is highly
flammable. Always use an approved container
and fill tank outdoors.
2. Before starting, fill fuel tank with fresh, clean diesel
fuel. For instructions on bleeding the fuel system on
initial start up or if fuel runs out, see engine manual.
CAUTION: See operation/start-up decal by foot
clutch pedal on machine before starting.
3. Turn key switch to preheat position. Hold in preheat
position for several seconds until glow plug indica-
tor light switches off.
4. Push throttle control in until it stops.
5. Depress foot clutch pedal, this will disengage drive belt
and enable engine to start.
6. Push in and hold Murphy switch push-button.
Continue to hold Murphy switch in when cranking
engine until engine is running.
7. Activate the starter switch. Release the switch as
soon as the engine starts. Do not crank over for
more than 10 seconds. Release Murphy switch after
engine is running; hold murphy switch in longer if
engine immediately kills after releasing.
Note: The Murphy switch system will shut the engine
off if the oil pressure is too low or if the engine
temperature is too high. If the engine will not run or
shuts of for these reasons, consult your local dealer.
8. Push center throttle control button in. Increase
throttle control to full throttle. Turn throttle control
knob clockwise to achieve maximum RPM.
9. Slowly let foot clutch pedal up. This will engage
drive belt and the rotor will turn. If the engine kills
when engaging the drive belt, release foot clutch
pedal more slowly.
10. When clutch is engaged, the foot pedal may vibrate
or shake until the engine and rotor have increased to
full running RPM (3000 RPM).
Do not move chipper during operation.
CAUTION: Obtain and wear safety glasses at all
times when operating the machine. Do not wear
loose fitting clothing. Use common sense and
practice safety to protect yourself from branches, sharp
objects and other harmful objects.
WARNING: Do not leave machine unattended or
attempt any inspection or service unless the engine
is stopped and the key switch is in OFF position.
28 HP Kubota Chipper Control Panel
Glow Plug
Indicator
No Charge
Indicator
Throttle
Murphy
Switch
Hour Meter
(Optional)
Temperature
Gauge
Key Switch
Pressure
Gauge