Echo 72928 Owners Manual v.2 - Manual (Page 12)

9
S E C T I O N 2
2.2 Identification
1. Extension Tray: Assists in feeding chipping
material. Folds for towing.
2. Feed Control Lever: Move the arm forward to
increase the feed rate. Push back to reverse the feed.
3. Chipper Chute: Feeds materials to the chipper
blades for chipping.
4. Discharge Tube: Chipped material exits through
this tube. Tube is adjustable 360 degrees.
5. Drive Belt Shield: Never remove shields when in
use.
6. Control Panel: Contains the key switch, throttle
control, Murphy switch, gauges, and choke control
(gas engine models only).
7. Fuel Tank: Fuel level indicator is located on top.
8. Pintle Hitch: Always use safety chains when
towing chipper.
9. Pivoting Tongue Jack: Always have in UP posi-
tion and clear from ground when moving. When in
use, place in DOWN position on a level surface.
Turn handle to raise or lower wheel.
10. Battery: (Not included.) Use group 22F 300 CCA
min.
11. Clutch Foot Pedal: Used to engage rotor assembly
drive belt.
NOTE: Your chipper
may be different
because of design
modifications at the
time of production.
1
2
3
4
5
6
7
8
9
10
11