Echo 74824 Owners Manual v.3 - Manual (Page 9)

Page 7 6" & 8" Bear Cat Chipper Operator’s Manual
Your chipper may arrive totally or partially assembled. If your
chipper arrives partially assembled, you may need to perform
the steps in this section. Refer to Figure 2.1 during
assembly.
Figure 2.1 - Chipper Assembly
S e c t i o n
Assembly
2
1. Remove from shipping crate.
2. Support the frame on wood blocks or other support de-
vice.
3. Mount the two tires and rims to the axle assembly with
the lug nuts (supplied).
4. Mount the trailer hitch assembly to the frame using three
3/8 X 3-1/2" bolts and locknuts (supplied).
5. Attach the Chipper Chute (see Section 2.2).
6. Attach the Optional Chute Extension Tray (see Section
2.3). The Chute Extension Tray is purchased separately.
7. Attach the Blower Discharge Tube (see Section 2.4).
8. Connect and adjust the Control Cable (see Section 2.5
and 2.6).
9. Install battery (see Section 2.7).
10. Check engine oil (see engine owner's manual) and fill
the gas tank with fresh gasoline.
11. Fill the hydraulic reservoir 2/3 full (see Section 5.12).
12. Your chipper should be ready to use.
2.1 ASSEMBLING THE MACHINE
IMPORTANT
DO NOT ATTEMPT TO START THE ENGINE AT THIS
TIME. Wait until you have read the complete Owner's
Manual.