Echo 76628S User Manual

Page 27

PN 14295-00 R

SERVICE & MAINTENANCE

BEFORE INSPECTINg OR SERVICINg ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,

DISENgAgE THE HYDRAULICS, OPEN SHIELD AND MAKE SURE ALL MOVINg PARTS HAVE COME TO A COMPLETE STOP.

WarnInG

5.6 ChIPPer anvIl

the four chipping blades should clear the chipper anvil

by 1/16 inch to 1/8 inch. The chipper anvil is adjustable
and reversible. all four sides of the anvil can be used for
chipping.

To adjust:
1. Lift rotor access cover and expose rotor.

2. Loosen the three 1/2 inch bolts that hold the chipper

anvil to the frame.

3. Measure the amount of clearance between chipping

blade and chipper anvil from inside of housing.

4. Adjust inward or outward to the desired measurement,

using the adjustment nuts provided.

5. tighten bolts on chipping block to 75 ft. lbs. and resume

operation.

If chipper anvil edge is damaged or worn unevenly, remove
the three bolts holding the anvil and use one of the other
three edges. Replace as necessary

Fig. # 29, Chipper anvil

5.7 aIr FIlter (DIesel shoWn)

Fig. # 30, Diesel Air Filter

both the kubota diesel and the honda gas engines used

on the 6” chipper have air filters. Refer to the Kubota

and Honda engine manuals, included with your machine,

for specific instructions on replacing and cleaning these

filters.