beautypg.com

Warning, Warning caution – Echo 76628S User Manual

Page 18

background image

PN 14295-00 R

16

OPERATION

4.2 startInG GasolIne ChIPPer

4.3 startInG DIesel ChIPPer

Make sure the chamber is empty before starting.

1. Reference the Honda Owners Manual.

2. Check engine oil level before starting. Do not overfill or underfill

oil. The Honda engine is equipped with an oil level sensor and

will not allow the engine to start in either condition.

3. Make sure the chipper engagement is in the start position.
4. Engage the choke if necessary.

5. Adjust throttle to start/idle position.
6. turn the key to the right to engage the starter.
7. Release the key after the engine starts.
8.

For a Cold Engine — gradually return the choke from the choke

position to the run position as the engine warms up.

Handle fuel with care. It is highly flammable.

Always use an approved container and fill tank
outdoors.

Move machine to a clear level area. do not
operate in the vicinity of bystanders.

WarnInG

note

1. Reference the Kubota Owners Manual. Also, make sure cutting

chamber is empty before starting.

2. Before starting, fill engine with oil to the correct level. See en-

gine manual for additional starting, operation and maintenance
instructions. Some oil usage is normal. Check level before each
use.

3. Before starting, fill fuel tank with fresh and clean diesel fuel. For

instructions on bleeding the fuel system on initial start up or if
fuel runs out, see engine manual.

4. Turn key switch to preheat position (to the left). Hold in pre-

heat position for several seconds until glow plug indicator light

switches off.

5. Place throttle control in the idle position.
6. Make sure the chipper engagement lever is disengaged.

7. Push in and hold the Murphy switch push-button. Continue to

hold Murphy switch in when cranking engine until engine is run-
ning.

8. Activate the starter. Release the switch as soon as the engine

starts. do not crank over for more than 10 seconds. after engine

is running; hold murphy switch until engine has oil pressure.

Handle fuel with care. It is highly flammable.

Always use an approved container and fill
tank outdoors.

Move machine to a clear, level area. do not
operate in the vicinity of bystanders.

The Murphy switch system will shut the engine

off if the oil pressure is too low or if the engine

temperature is too high. If the engine will not
run or shuts off for these reasons, consult your
local dealer.

Allow the machine to come to complete stop
before inspection or servicing.

WarnInG

WarnInG

CautIon

note