Echo 76628S - Manual (Page 14)

PN 14295-00 R 12
ASSEMBLY
2.8 rear staBIlIzer
2.9 Battery
The chipper is shipped with a battery. The battery is connected to the battery cables using the two 1/4” bolts and nuts
found in the parts kit. To connect:
1. Route the battery cables to the proper battery terminals, hooking positive to positive, and negative to negative.
2. Connect cables with 1/4” bolt and nuts. Tighten nuts to proper torque.
3. Check battery for proper fluid level and fill if necessary.
4. If necessary, charge battery.
the rear stabilizer is installed by sliding the stabilizer into the corresponding slot on the rear of the chipper frame. the
stabilizer is secured and adjusted with the provided snap pin.