Warning – Echo 76628S User Manual
Page 16
PN 14295-00 R
14
FEATURES & CONTROLS
the key is located on the control panel on both the diesel and
gas engines. turn the key to the right to activate the electric
start. on diesel models turning the key to the left activates the
glow plug. DO NOT START THE MACHINE WITH THE CHIP-
PER ENgAgED.
used to lift feed roller for unplugging.
To activate slowly push the handle toward the ground. To dis-
engage the machine move the handle back up to the original
position (See Fig. #15).
to engage the feed roller move the control arm. the cycle of the
control arm, forward to back, is R, F, N, R.
Prevents the chipper from tipping from heavy loads when dis-
connected from the towing vehicle.
Shows remaining fuel.
this controls the speed of the engine. on diesel models the
throttle is adjusted by twisting, or by pushing the button and
pushing or pulling.
Used to adjust the height of the hitch.
Use this to start the gasoline engine when cold. Move switch to
original position as engine warms.
3.1 key
3.2 throttle
3.3 Choke
3.4 ChIPPer enGaGement
3.5 FeeD roller enGaGement
3.8 rear staBIlIzer
3.9 Bottle jaCk
3.10 tonGue jaCk
3.11 Fuel GaGe
3.12 murPhy sWItCh
3.6 Chute rotor
3.7 DIsCharGe CaP rotor
directs the discharge of chipped material horizontally.
directs the discharge of material vertically
See starting instructions for diesel engines. The murphy switch
will not let the engine run if the oil pressure is to low, or the en-
gine temperature too high. To start the engine, this switch must
be held until oil pressure is present on the gauge.
To prevent personal injury or property damage: Shut off engine, disconnect spark plug wire, and make sure that
all moving parts have come to a complete stop, before servicing, adjusting or repairing.
WARNINg
Fig. #15, Engagement instructions