Echo 7812086 Owners Manual v.2 - Manual (Page 10)

Bear Cat Owners Manual 6
Section
#
WARNING
Before inspecting or servicing any part of this machine, shut
off power source, remove key, disconnect the battery cables
and make sure all moving parts have come to a complete
stop.
If any bolts or nuts are dropped in the machine, be sure to
remove them before starting the machine.
IMPORTANT
2.1 CONNECTING THE BATTERY
A battery ships with the chipper. If the battery is not connected,
refer to the battery owners manual for instructions on connecting
the battery and for service and maintenance information.
WARNING
To avoid sparks and a possible explosion or fire due to a short
circuit, do not touch the positive (+) battery terminal and any
surrounding metal with tools, jewelry or other metal objects.
When installing battery cables, connect the positive (+) cable
first and the negative (-) cable last.
Assembly
2.2 CHECKING/ADDING HYDRAULIC FLUID
Hydraulic fluid drives the feed roller. The hydraulic pump is
attached to the motor or connected to the motor with a belt.
The hydraulic pump requires premium hydraulic fluids containing
high quality rust, oxidation, and foam inhibitors. These include
premium turbine oils, API CD engine oils per SAE J183,
M2C33F or G automatic transmission fluids meeting Allison C-
3 or Caterpillar TO-2, and certain specialty agricultural tractor
fluids.
If system has no oil, follow this startup procedure:
Clean all system components (reservoir, fittings, etc.) before
starting the hydraulic pump.
After filtering the hydraulic fluid, fill the hydraulic reservoir.
Fill the inlet line leading from the reservoir to the pump
before start-up. Loosen the fitting at the pump on this inlet
line until oil bleeds out.
Start the engine and run at the lowest possible RPM.
As you purge air from the unit, the oil level in the reservoir
1.
2.
3.
4.
5.
For best results use only clean, fresh, fuel. Purchase fuel in small
quantities and store in clean, approved containers. Do not mix
gasoline or alcohol with diesel fuel.
REFER TO THE ENGINE OWNERS MANUAL FOR FURTHER
FILLING INSTRUCTIONS.
2.5 FILLING THE TANK
Fuel is highly flammable and its vapors are ex-
plosive. To prevent personal injury or property
damage:
Store fuel only in approved containers, in well
ventilated, unoccupied buildings, away from
sparks or flames. Do not fill the fuel tank while the engine is
hot or running. Spilled fuel could ignite if it comes in contact
with hot parts. Do not start the engine near spilled fuel. Never
use fuel as a cleaning agent.
DANGER
IMPORTANT
Do not attempt to start the engine at this time. Wait until you
have read the complete starting instructions in the Operation
Section of this manual.
2.3 CHECKING/ADDING MOTOR OIL TO
ENGINE
Check the oil level and, if needed, fill the engine crankcase
with the type and amount of oil specified in the engine owners
manual.
2.4 CHECKING/ADDING COOLANT
The diesel engine is tested before shipping. In order to test the
equipment, the fluid levels are filled. However, before starting
the machine, check the coolant level in the radiator and coolant
reserve tank (if equipped) to ensure it is with in the proper
operating range (between FULL and FILL). Refer to the engine
owner's manual for specific instructions on checking and adding
coolant.
will drop and bubbles may appear in the fluid. Refill the
reservoir as necessary.
Run the feed roller in both directions for several minutes until
any remaining air purges from the unit. Refill the reservoir
as necessary.
Shut down the engine, check for and correct any fluid leaks,
and check the reservoir level. Add fluid if necessary. The
hydraulic gear pump is now ready for operation.
6.
7.
2