Service & maintenance, 1 maintenance schedule, Service & maintenance 5 – Echo CH4400 Owners Manual v.2 User Manual
Page 18: Warning, Service and maintenance schedule, Frequency
4 INCH CHIPPER
14
Section
SERVICE & MAINTENANCE
5
WARNING
5.1 MAINTENANCE SCHEDULE
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action
taken. This schedule is designed for units operating under
normal conditions. If the unit is operating in adverse or
severe conditions, it may be necessary for the items to be
checked and serviced more frequently.
SEE ENGINE OWNER’S MANUAL FOR FURTHER
ENGINE MAINTENANCE AND TROUBLESHOOTING
INFORMATION.
To prevent personal injury or property damage: shut
off engine and make sure that all moving parts have
come to a complete stop before, servicing, adjusting or
repairing. Disconnect the battery and remove ignition
key where applicable.
SERVICE AND MAINTENANCE SCHEDULE
FREQUENCY
COMPONENT
MAINTENANCE
REQUIRED
REFER TO
ENGINE
OPERATOR’S
MANUAL
BEFORE
EACH
USE
EVERY
8
HOURS
EVERY
25
HOURS
EVERY
50
HOURS
EVERY
YEAR
AIR CLEANER
CHECK AND CLEAN (1)
AIR INTAKE
CLEAN (1)
ENGINE OIL
CHANGE (1)
FUEL FILTER
REPLACE
SPARK PLUG
CHECK CONDITION AND GAP
ENGINE OIL
CHECK/FILL
FUEL TANK
CHECK/FILL
ALL INTERNAL AND EXTERNAL NUTS
AND BOLTS
CHECK TIGHTNESS
TIRE PRESSURE
CHECK
CHIPPER ANVIL
CHECK CLEARANCE AND RE-
TORQUE TO 75 FT-LBS. (2)
CHIPPER BLADES
CHECK SHARPNESS AND RE-
TORQUE TO 25 FT-LBS
ENTIRE MACHINE
CLEAN
DRIVE BELT
CHECK
BELT TENSION
CHECK
BELT/PULLEY ALIGNMENT
CHECK
GREASE ZERKS
LUBE
WHEEL BEARINGS
CHECK AND REPACK
(1) PERFORM MORE FREQUENTLY UNDER EXTREMELY DUSTY CONDITIONS.
(2) PERFORM MORE FREQUENTLY WHEN CHIPPING DRY OR DIRTY WOOD.
As the Limited Warranty states, failure by the Owner to perform normal maintenance will void the machine’s warranty.
The aggressive, high-speed nature of chipping REQUIRES THE OWNER TO PERFORM THE ABOVE LISTED NORMAL
MAINTENANCE. Special consideration to maintain and re-torque the CHIPPER ANVIL, CHIPPER BLADES, AND ALL
INTERNAL AND EXTERNAL NUTS AND BOLTS is the sole responsibility of the Owner. Failure by the Owner to do so shall
be cause for denial of warranty.