Echo CH5540HXE - Manual (Page 2)

Instruction Sheet
COMPLETE
CIRCUIT
WHT
RED/YEL
RED/GRN
TRI-COLOR LED
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
9
10
3. install tri-color led into control box so that the silver terminal is located at the three o'clock
position from the inside of the box.
4. connect wires to the back of the reset switch (6) and tri-color led (7). ensure wires for the
tri-color led are connected as shown in diagram.
5. install proximity sensors (4) into control box (1) using the nuts (5) previously removed. ensure
that sensors are put into the same hole that they came out of and that there is a 1/32” gap
between the sensor and switch control bar. ensure not to overtighten damage to sensor may
occur.
6. Install control box cover (2) on control box (1) using four serrated flange bolts (3).
CH6670HXE and CH6993HXE Chipper Chute