Echo CH9540H Owners Manual v.2 - Manual (Page 19)

PTO CHIPPERS 15
ENGLISH
SERVICE & MAINTENANCE
5.6 LubRICATIoN
Two bearings on the rotor shaft. •
Two bearing on the bottom jack shaft. •
One zerk on the feed roller assembly. •
One zerk on discharge chute. •
lubricate the machine periodically with a lithium-based
grease. extreme working conditions will require more
frequent greasing.
Grease the following points every 50-100 hours of
operating time:
Discharge chute
Jack shaft
Jack shaft (other side
of machine)
Feed roller assembly
Rotor shaft
Rotor shaft (other side of machine)
Polyurea and lithium-based greases are not compatible.
Mixing the two grease types may lead to premature
failure.
ImPoRTANT
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
NoTE