Echo CH9540H Owners Manual v.7 - Manual (Page 19)

PTO CHIPPERS 15
ENGLISH
Section
SERVICE AND MAINTENANCE SCHEDULE
FREQUENCY
COMPONENT MAINTENANCE REQUIRED
BEFORE
EACH
USE
EVERY 8
HOURS
EVERY 25
HOURS
EVERY 50
HOURS
EVERY
200
HOURS
HYDRAULIC OIL CHECK/FILL
ALL INTERNAL AND EXTERNAL
NUTS AND BOLTS
CHECK TIGHTNESS
CHIPPER ANVIL
CHECK CLEARANCE AND RETORQUE TO
75 FT-LBS. (1)
CHIPPER BLADES
CHECK SHARPNESS AND RETORQUE
MODELS CH8540 AND CH9540H TO 120
FT-LBS. TORQUE MODEL CHF9540H
TO 25 FT-LBS. (1)
ENTIRE MACHINE CLEAN
PTO CROSS JOURNALS LUBE
PTO INNER TUBES LUBE
PTO SHIELD RETAINING
BEARING
LUBE
DRIVE BELT CHECK
HYDRAULIC DRIVE BELT CHECK
BELT TENSION CHECK
BELT/PULLEY ALIGNMENT CHECK
GREASE ZERKS LUBE
HYDRAULIC OIL FILTER REPLACE
(1) PERFORM MORE FREQUENTLY WHEN CHIPPING DRY OR DIRTY WOOD.
As the Limited Warranty states, failure by the Owner to perform normal maintenance will void the machine’s warranty.
The aggressive, high-speed nature of chipping REQUIRES THE OWNER TO PERFORM THE ABOVE LISTED NORMAL
MAINTENANCE. Special consideration to maintain and re-torque the CHIPPER ANVIL, CHIPPER BLADES, AND ALL
INTERNAL AND EXTERNAL NUTS AND BOLTS is the sole responsibility of the Owner. Failure by the Owner to do so shall
be cause for denial of warranty.
SERVICE & MAINTENANCE
5
WARNING
The items listed in this service and maintenance schedule
are to be checked, and if necessary, corrective action taken.
This schedule is designed for units operating under normal
conditions. If the unit is operating in adverse or severe
conditions, it may be necessary for the items to be checked
and serviced more frequently.
SEE ENGINE OWNER’S MANUAL FOR FURTHER
ENGINE MAINTENANCE AND TROUBLESHOOTING
INFORMATION.
To prevent personal injury or property damage: shut off
engine and make sure that all moving parts have come to
a complete stop before servicing, adjusting, or repairing
machine. Disconnect the battery and remove ignition key
where applicable.