Echo CH9540H Owners Manual v.7 - Manual (Page 11)

PTO CHIPPERS 7
ENGLISH
ASSEMBLY
2.3 ATTACH CHUTE - HYDRAULIC FEED MODELS WITHOUT SAFETY BAR
1. Remove chipper from shipping crate. Place unit
on a level surface before assembling. See the
Torque Chart in Section 7 for the recommended
torque for tightening bolts and screws.
2. Attach the chute support to the front side of the
chipper base with one 3/8 x 1" hex bolt, washer
and nut.
3. Attach the chipper chute to the feed roller with
eight 3/8 x 1-1/2" carriage bolts, washers, and
nuts. Thread the bolts from inside the chute. Do
not tighten completely at this time.
4. Attach the chute support to the chute through the
middle hole on the extension tray hinge using
existing hardware.
5. Tip the extension tray up and slide it over the
chipper chute as shown here. Make sure to
position the lip on the extension tray behind the
lip on the chipper chute.
6. Insert five 3/8 x 1" carriage bolts through the five
outside holes on the extension tray and hinge.
Adjust so the tray can be locked in upright postion
with the lock pin on the chute. Secure the bolts with
washers and nuts.
7. Tighten the eight bolts holding the chute in
place.
8. Connect the three wires coming from the feed chute
to the connectors that are located underneath the
feed roller, matching ziptie colors.
Figure 2.4
Figure 2.5
Figure 2.6