Echo CH9540H Owners Manual v.7 - Manual (Page 14)

PTO CHIPPERS 10
Section
1
2
3
8
10
1. Discharge tube: Chipped materials will exit through
this tube. It is adjustable 360 degrees. The discharge
tube for the fine chip model is not adjustable. It is
designed to blow materials onto the ground.
2. Manual holder: Conveniently stores your owner's and
parts manuals.
3. Chipper chute: Feed materials into the chipper
chute.
4. Safety bar: (Not available on all models.) Push
the safety bar to stop the feed roller in event of an
emergency.
5. Reset/Override button: (Not available on all models.)
When the safety bar has been activated, the red light
will go on and the feed roller will stop. Push the reset/
override button to resume forward feed. Upon start-up,
the safety bar light will be on and will need to be reset
before the feed roller will operate.
FEATURES & CONTROLS
6. Feed roller lift jack: Use the jack to lift the feed roller
to inspect or service the machine. Secure feed roller
in the raised position with the snap pin.
7. Hydraulic fluid tank: Inspect level of fluid each time
the machine is operated.
8. Three-point connection: Mounts chipper to tractor
three-point hitch.
9. Controller light: When the light is flashing green
increase RPM. The feed roller can be shifted into
Forward when the controller light is steady green. See
Section 6 for more information.
10. Disk lock and pin: Use the disk lock to hold the chipper
disk in place when doing any maintenance work on it.
See Sec. 5.2.
11. Feed roller control bar: Move the feed roller control
bar to begin feeding materials into the chipper.
12. Feed roller speed control: Turn clockwise to increase
feed roller speed and counterclockwise to decrease.
3
CH8540
Understanding how your machine works will help you achieve the best results when using your machine. The following
descriptions define the features and controls of your machine.