BURY CC 9068 APP USER Manual - Manual (Page 34)

34
Operating guidelines
Audio
In this area you have the possibility to change the audio settings of the
HFCK.
The HFCK is sold with four Ringtones from which you can respectively
select one. With „NEXT“ or „PREVIOUS“ you can navigate in the list.
With „ACCEPT“ the ring tone is selected. If you would like to use your
mobile phone’s ring tone, please select the first entry in the menu.
Please remember, however, that not every mobile phone can transfer
its ring tone to the HFCK.
The volume level for the voice feedback and the selected ring tone can
be set in an additional sub menu. Available as voice commands are
„LOUDER“, „LESS“, „MAXIMUM“, „MINIMUM“ and „ACCEPT“.
For some radios it may cause problems if the HFCK starts with voice
response immediately after the mute signal. Some radios need some
time for a corresponding activation and reaction to the mute signal.
This will be indicated to you through the fact that you don’t hear the
signal tone at the start of the voice control. To avoid this effect, you can
enter a maximum delay of up to three seconds in the „MUTE DELAY“
menu item. It is only after this time has elapsed that the HFCK begins
with the voice feedback.
Certain mobile telephones offer the possibility of being able to install
and operate a navigation solution. On many mobile phones, the sug-
gested directions are only transferred via the Bluetooth A2DP profile. If
you have not connected a suitable cable to the LINE-OUT output of the
HFCK and to the radio however, you are not able to hear these instruc-
tions.
With the External Audio menu item, it is possible to place these in-
structions on the PHONE-OUT output of the HFCK. This means that the
direction instructions are read out in monotone and the radio is also
muted. The HFCK takes priority with its functions, however, which
means that if the voice control is active or in the event of an incoming
call, any direction instructions that are being issued at that time will be
muted.
Please note:
If the function is activated it is not possible to listen to X
music via A2DP via the LINE-OUT output.
The “Balance” command is used to compensate or adjust the volume
between the left and right side. “Installation” involves two options:
- Option 1 (all through the box):
Connection - ISO-power connector plugged in, ISO-audio connector
connected (box active).
Phone call - uses two front speakers and an internal amplifier in the
box. Car speakers are disconnected from the radio and connected to
the box (active). RadioMute line is also active and will turn off the radio
(Mute or switching to PHONE IN mode, depending on the radio).
Audio
Ringtones
Play
Select
Volume
Speech
Ringtone
Mute delay
External audio on
Balance
Installation