Google Search Appliance Connectors Deploying the Connector for Active Directory - Manual (Page 9)

Deploy the Connector for Active Directory
Because the Connector for Active Directory is installed on a separate host, you must
establish a relationship between the connector and the search appliance.
To deploy the Connector for Active Directory, perform the following tasks:
1. Configure the search appliance
2. Install the Connector for Active Directory
3. Optionally, configure adaptor-config.properties variables
4. Run the Connector for Active Directory
Step 1 Configure the search appliance
For the search appliance to work with the Connector for Active Directory, the search
appliance needs to be able to accept feeds from the connector. To set up this capability,
add the IP address of the computer that hosts the connector to the list of Trusted IP
addresses so that the search appliance will accept feeds from this address.
To add the IP address of the computer that hosts the connector to the list of trusted IP
addresses:
1. In the search appliance Admin Console, click Content Sources > Feeds.
2. Under List of Trusted IP Addresses, select Only trust feeds from these IP
addresses.
3. Add the IP address for the connector to the list.
4. Click Save.
Step 2 Install the Connector for Active Directory
This section describes the installation process for the Google Search Appliance Connector
for Active Directory on the connector host computer. This connector version does not
support installing the connector on the Google Search Appliance.
You can install the Connector for Active Directory on a host running one of the
supported
operating systems .