I.R.I.S. IRISPen Executive 6 for Mac - Manual (Page 29)

C HAPTER 4 - B ASIC PARAMETERS
25
clipboard before it is pasted (automatically or not, see below) in
the active application. If the data is pasted automatically (default
value, see below), this method is quicker than Keyboard
Emulation.
If the data is not pasted automatically (see below), this allows
e.g. to change the cursor location in the active application before
the data is inserted.
Scanning multiple lines
You can scan multiple lines at the same time and send them to
the clipboard. In this case, you will operate exactly as for single
lines: scan then paste the data manually in the active application.
To scan multiple lines, tick the option Multiple Lines from the
Settings menu.
• If you have selected Clipboard as output target, you have access
to the following advanced options via the button Choose the
output target in the IRISPen Palette or the command Options
from the Settings menu. Select the required options and values,
then click on OK to confirm.
Include font and size
You can determine the font and the size of the data to be inserted
in the active application. Tick the button Include font and size
and select the required font and size via the arrows on the right.
Paste automatically (default value)
If this option is selected, the software automatically pastes the
data that has been sent to the clipboard in the active application.