JLG 15VPSP Operator Manual - Manual (Page 19)

SECTION 2 - PREPARATION AND INSPECTION
3120796 – JLG Lift – 2-3
when using the machine for spraying paint or any material
which could cover these surfaces and reduce legibility.
Operation and Safety and ANSI
Responsibilities Manual
Ensure a copy of manual is enclosed in the manual stor-
age box.
Lubrication
For those parts pointed out in the Walk-Around Inspection
requiring lubrication, refer to the Lubrication Chart, Figure
2-4., for specific time interval requirements.
Hydraulic oils must have anti-wear qualities at least to API
Service Classification GL-3, and sufficient chemical stabil-
ity for mobile hydraulic system service. JLG Industries,
recommends Mobilfluid 424 hydraulic oil, which has an
SAE viscosity of 10W-30 and a viscosity index of 152.
For cold weather applications, i.e. when temperatures
remain consistently below +20°F (–7°C) JLG recom-
mends using Mobil DTE 13 hydraulic oil.
2.5 DAILY FUNCTIONAL CHECK
TO AVOID INJURY DO NOT OPERATE A MACHINE UNTIL ALL
MALFUNCTIONS HAVE BEEN CORRECTED. USE OF A MALFUNC-
TIONING MACHINE IS A SAFETY VIOLATION.
Once the Walk-Around Inspection is complete, a func-
tional check of all systems should be performed in an area
free of overhead and ground level obstructions. Perform a
functional check in accordance with the following proce-
dures:
Set-up machine for operation, according to instructions in
Section 4-3, “Machine Operation”.
Ground Controls Function Check
1. With key switch turned to GRND position (clock-
wise), operate the platform up and down switch
(located in lower access hole with hydraulic fluid res-
ervoir). Raise and lower platform 2 ft. to 3 ft. (.5m to
Figure 2-1. Daily Walk-Around Inspection.
1
2
4
6
8
9
7
5
3
Daily Walk-Around Inspection Items
1. Drive and Castor Wheels 4. Battery/Battery Charger 7. Mast Assembly
2. Base Frame 5. Ground Controls 8. Platform Controls
3. Motor/Pump/Reservoir Unit 6. Manual Brake Release Control 9. Platform Assembly