JLG 110HX ANSI Service Manual - Manual (Page 77)

SECTION 2 - PROCEDURES
3120636 – JLG Lift – 2-53
d. Place another bearing cone (29) over planet
shaft and into cluster gear. This is a slip fit.
e. Slide largest spacer (26) onto planet shaft.
f. Bearings in cluster gear must be seated by
applying 25-50 lbs. (11-23 kg) against them and
rotating cluster gear at the same time. This can
be done by sliding a second spacer (26) over
planet shaft and pushing downward while rotat-
ing the gear.







g. See if retaining ring (25) will fit onto planet shaft
groove. If not, try smaller spacer (26) until retain-
ing ring fits. This will set bearings at 0.000-0.152
mm.
h. Place carrier on edge of a table with one set of
holes hanging over the edge. Side with roll pin
hole should be down.
i. Place bearing cones (29) into cluster gear.