JLG 110HX ANSI Service Manual - Manual (Page 16)

SECTION 1 - SPECIFICATIONS
1-4 – JLG Lift – 3120636
Deutz F4L912 Engine
Single Viscosity Oils (CD-SE, CD-SF)
Multi-Viscosity Oils (CD-SE, CD-SF)
* This viscosity can be used at colder temperatures only
with engine oil preheating.
Cummins 4B3.9C Engine
Single Viscosity Oils
Multi-Viscosity Oils (MS, SD, SE).
NOTE: Crankcase oil should meet one of the following API
classification grades: SE/CC, SE/CD, SF/CC, SF/
CD.
NOTE: Hydraulic oils must have anti-wear qualities at least
to API Service Classification GL-3, and sufficient
chemical stability for mobile hydraulic system ser-
vice. JLG Industries recommends Mobilfluid 424
hydraulic oil, which has an SAE viscosity index of
152 .
NOTE: When temperatures remain consistently below 20
degrees F (-7 degrees C.), JLG Industries recom-
mends the use of Mobil DTE11.
NOTE: Aside from JLG recommendations, it is not advisable
to mix oils of different brands or types, as they may
not contain the same required additives or be of
comparable viscosities. If use of hydraulic oil other
than Mobilfluid 424 is desired, contact JLG Indus-
tries for proper recommendations.
When Outside Temp is Consistently
Use SAE Viscosity
Number
-20° to +25° F (-29° to -4° C) *10W
+15° to +50° F (-10° C to +10° C) 20W-20
+40° to +85° F (+4° to +30° C) 30
Above 75° F (+24° C) 40
When Outside Temp is Consistently
Use SAE Viscosity
Number
-40° to +75° F(-40° to +24° C) *5W-20
(Synthetic)
-5° to +70° F(-21° to +21° C) 10W-30
-5° to +85° F(-21° to +30° C) 10W-40
+15° to +75° F(-10° to +24° C) 15W-30
Above +15° F(-10° C) 15W-40
When Outside Temp is Consistently
Use SAE Viscosity
Number
-22° to +23° F (-30° to -5° C) 10W
+14° to +50° F (-10° C to +10° C) 20W-20
+41° to +86° F (+5° to +30° C) 30
Above 77° F (+25° C) 40
When Outside Temp is Consistently
Use SAE Viscosity
Number
-40° to +77° F(-40° to +25° C) 5W-20
(Synthetic)
-4° to +68° F(-20° to +20° C) 10W-30
-4° to +86° F(-20° to +30° C) 10W-40
+14° to +77° F(-10° to +25° C) 15W-30
Above +14° F(-10° C) 15W-40
Table 1-3.Hydraulic Oil
Hydraulic System Operating
Temperature Range
SAE Viscosity
Grade
0° to +23° F(-18° to -5° C) 10W
0° to +210° F(-18° to +100° C) 10W-20, 10W-30
+50° to +210° F(+10° to +99° C) 20W-20